Your KIRISUN radio generates RF electromagn-
etic energy during transmit mode. This radio is desig-
ned for and classified as “Occupational Use Only”,
meaning it must be used only during the course of em-
ployment by individuals aware of the hazards, and the
ways to minimize such hazards. This radio is NOT int-
ended for use by the “General Population” in an unc-
ontrolled environment.
This radio has been tested and complies with the
FCC RF exposure limits for “Occupational Use Only”.
In addition, your KIRISUN radio complies with the fol-
lowing Standards and Guidelines with regard to RF
energy and electromagnetic energy levels and evalu-
ation of such levels for exposure to humans:
FCC OET Bulletin 65 Edition 97-01 Supplement C,
Evaluating Compliance with FCC Guidelines for Hu-
man Exposure to Radio Frequency Electromagnetic
Fields.
American National Standards Institute (C95.1-
1992), IEEE Standard for Safety Levels with Respect
to Human Exposure to Radio Frequency Electroma-
gnetic Fields, 3 kHz to 300 GHz. American National
Standards Institute (C95.3-1992), IEEE Recommen-
ded Practice for the Measurement of Potentially Haz-
ardous Electromagnetic Fields– RF and Microwave.
The above-mentionde accessories are authorized
for use with this product. Use of accessories other than
those (listed in the instruction) specified may result
in RF exposure levels exceeding the FCC require-
ments for wireless RF exposure.
To ensure that your expose to RF
electromagnetic energy is within the
FCC allowable limits for occupational
use, always adhere to the following
guidelines
DO NOT operate the radio without a proper ante-
nna attached, as this may damaged the radio and
may also cause you to exceed FCC RF exposure
limits. A proper antenna is the antenna supplied
with this radio by the manufacturer or antenna sp-
ecifically authorized by the manufacturer for use
with this radio.
DO NOT transmits for more than 50% of total radio
use time (“50%duty cycle”). Transmitting more than
50% of the time can cause FCC RF exposure co-
mpliance requirements to be exceeded. The radio
is transmitting when the “TX indicator” lights red.
You can cause the radio to transmit by pressing
To Next Page
Loading...
Need help?
General
