3
4
After about five hours of charging, the red LED will
be out, and the green LED will be on, which indicates
that the battery is fully charged.
Keep the battery in the charger under green LED
on status for 1 to 2 hours, and then remove the battery.
In doing so, the battery can reach its best performance.
Then you can remove the adapter from the AC power
output socket.
If the yellow LED flashes, it indicates that the ch-
arging temperature or the circuit is abnormal, and the
charger is in the protected status, in which you should
not charge the battery compulsorily.
Please remove the battery and cut the power of the
charger.
Note:
* The radio battery has not been charged in the fac-
tory; please charge the battery before using the radio
for the first time.
* Both KB-56A lithium polymer battery and KB-56B
lithium polymer battery of the company are applicable
to this radio.
* Charge the battery for several times for the first ch-
arging after purchase or after the radio is laid aside for
a long time (longer than 2 months), so that the battery
can reach its normal battery capacity. Meanwhile, pl-
ease make sure to charge the battery at least once
every three months.
* It is better not to recharge the battery if the battery is
fully charged or the radio is not in its low battery alarm
status; otherwise, the battery's service life and perf-
ormance may be influenced. After the battery charging
is finished, please remove it from the charger.
* When the radio enters the low battery alarm status,
please recharge the battery before reusing it. Do not
turn on the radio compulsorily; otherwise, the service
life and performance of the battery may be influenced.
* KB-56A/KB-56B battery is provided with an internal
protective circuit. When the battery power is too low,
the battery will cut the power supply automatically. If
it is charged on the charger now, the red LED will not
be on immediately. After about 1 to 5 minutes, the
charging indicator will turn normal.
2.2 Install/Remove the battery
Install the battery:
Align the two protrusions at the upper end of the
battery to the slots at the upper end of the shell of the
radio and insert them.
Press the lower end
of the battery down until
the latch of the radio com-
pletely bounces out, and the
battery is locked.
Remove the battery:
To remove the battery, please push the latch at the
lower end of the radio forward, the lower part of the
battery will bounce up automatically. Then, loose the
belt clip slightly and remove the battery.
To Next Page
Loading...
Need help?
General
