Kirisun PT568 Instruction Manual

9 10
NO.
Function Description
5
6
7
8
9
10
11
12
13
Emergency Alarm
Off
Scan
Nuisance Delete
(temporary)
High/Low
Power Switch
Momentary
Monitor
Monitor
Momentary
Squelch Off
Squelch Off
Lone Worker
Reset
Press the preprogrammed “Emergency Alarm Off” button to quit the Emergency Alarm
Mode.
Press the preprogrammed “Scan” button to enable/disable the system scan function.
If the scan function of the radio is enabled, and the radio stays at the noise channel,
press the preprogrammed “Nuisance Delete” button to delete the noise channel temporarily.
Press the preprogrammed “High/Low Power Switch” button to switch between high and
low transmitting power of the radio.
Press and hold the preprogrammed “Momentary Monitor” button to disable CTCSS, DCS
signaling, and release the button to resume normal operation.
Press the preprogrammed “Monitor” button to disable CTCSS, DCS signaling, and you can
receive signals that cannot be heard under normal operation. Press it again to resume
normal operation.
Press and hold the preprogrammed “Momentary Squelch Off” button to open squelch;
release it to resume normal operation.
Press the preprogrammed “Squelch Off” button to open squelch. Press it again to resume
operation.
If Lone Worker function is enabled, press the preprogrammed “Lone Worker Reset”
button to reset the lone worker timer, and the timer starts again.
6. Auxiliary function
6.1 Time-Out Timer (TOT)
1) TOT Function
a) TOT timer is provided to prevent the user from
talking too long and occupying the channel for a long
time, and to avoid too long continuous transmission
of the radio.
b) Set the time limit for continuous transmission
of the radio. When the transmission time exceeds the
preset time limit, the radio will make alarm and stop
transmission.
2) TOT Rekey Time
a) Set the time period in which the radio is prohib-
ited to transmit after the transmission time exceeds
the preset time limit.
b) During the period in which the radio is prohibited
to transmit, if the PTT button is pressed, an alert tone
will be sounded, and the transmission is prohibited.
3) TOT Pre-alert
a) The radio will alarm in advance before the trans-
mission is stopped by the timer.
b) After the pre-alert tone, if the transmission time
exceeds the preset time limit, the timer will act.
4) TOT Reset Time
a) The time period from the releasing of the PTT button
to the reset of the timer.
b) If the release time of the PTT button is shorter than
the TOT reset time, the timer will continue to countdown.
6.2 Battery Saving
The dealer can set the power saving mode of the
battery.
If this function is enabled, and the radio receives no
signal or no operation has been performed for ten se-
conds, the radio will enter Battery Saving Mode. If the
radio receives signals or the user operates the radio,

Kirisun PT568 Specifications

General

Brand	Kirisun
Model	PT568
Category	Transceiver
Language	English