1 2
Quantity
1
1
1
1
1
1
1
Contents
1. Open Package Inspection........................1
2. Preparation.............................................2
2.1 Charge the battery................................3
2.2 Install/Remove the battery.....................4
2.3 Install the antenna................................5
2.4 Install external speaker/MIC.................6
2.5 Install the belt clip..................................7
3. Radio Overview........................................8
4. Basic Operation.......................................9
5. Functions of Programmable Buttons.......10
6. Auxiliary Functions.................................11
7. Wired Clone Mode................................. 12
8. Troubleshooting Guide...........................13
9. Major Specifications...............................14
10. FCC Notice.........................................15
1. Open Package Inspection
Firstly, please take the radio out of the pac-
kage box carefully. We recommend checking
the supplied accessories in the following table
before disposing the packing material. If any
article is found lost or damaged, please contact
the distributor without delay.
Accessories
Antenna
Battery
Belt Clip
Rapid Charger
Power Adapter
Hand Strap
Instruction Manual
Antenna
Power
Adapter
Belt Clip
Rapid
Charger
Hand Strap
Battery
2. Preparation
2.1 Charge the battery
Insert the cable plug of
the adapter into the jack at
the back of the charger.
Then insert the adapter into an
applicable AC power output socket. The three LEDs
will flash for about one second, and then the green LED
will be constantly on when the charger is normal.
Insert the battery to be charged or the radio into the
charger. Do remember to
turn off the radio before
inserting it into the charger.
Make sure that the battery
and the charger terminal
are fully and reliably
connected with each other.
When the red LED is on, the charging starts.
To Next Page
Loading...
Need help?
General
