First connection via ethernet
Page 15
002-808e-07.20
Adapting network settings
If required, the network settings for the marked device (see
Figure 7: Network Setup Wizard, list with found devices) can
be adapted by clicking on «Next». The following options can
be configured for this purpose:
Device name:
The device name is displayed in the Network Setup Wizard
as well as in the web interface. In networks that support
name resolution, the device name can be entered directly in
the address field of the web browser to access the device.
Address mode
The address modes «DHCP with Auto-IP» and «Static IP»
are supported. Configure the network settings as desired
and click on «Next» until you reach the final review page.
To apply the changes, press «Update»
Information regarding network connection
The Kistler Network Setup Wizard finds Kistler network
devices throughout the network. It even scans multiple
network interfaces on a computer. However, if there are
several routers or switches between the computer and the
measuring amplifier, this search might not be successful
under certain circumstances.
To Previous Page
Loading...
