Sauna/Infrarot/Softclima/Infraclima
PAGE 10
50701103/02.13
5. Operation
5.6. Starting Softclima
' For operation follow the prerequisites and the program table on page 9!
FIRE RISK!
Before starting the control system, always check that there are no inflammable objects
on or near the sauna heater.
' Start the evaporator as described in 5.9., 5.11.
1. Press the MODE button.
. The last selected mode and settings appear on the display.
2. If necessary press the MODE button again until the symbol Cloud appears
without the IR in
the display.
. After the heating phase the Bather symbol
appears on the display. The cabin is ready for
use.
' If you want to change the values for the selected program - see Section 6.
5.7. Starting Infraclima
' For operation follow the prerequisites and the program table on page 9!
FIRE RISK!
Before starting the control system, always check that there are no inflammable objects
on or near the sauna heater.
' Start the evaporator as described in 5.9., 5.11.
1. Press the MODE button.
. The last selected mode and settings appear on the display.
2. If necessary press the MODE button again until IR and the Cloud symbol
appear on the
display.
. After the heating phase the Bather symbol appears on the display. The cabin is ready for
use.
' If you want to change the values for the selected program - see Section 6.
To Next Page
Loading...
