Klafs 16033 - User Manual

Questions and Answers

C
Christopher HenryAug 8, 2025
What to do if the Klafs 16033 Spa Accessories cabin light is not illuminated and the fan won't run?
- N
  Nicholas HallAug 8, 2025
  If the cabin light isn't working, and the fan won't run, start by checking the lamp, it might be defective. If so: 1. Disconnect the control unit from the mains. 2. Replace the lamp with one that has the same power rating. Also, check the FI switch and the fuse in the power supply to ensure there is mains voltage. Another potential cause is a triggered fuse SI100. Replace the fuse SI100 (1.25 AT) or contact Klafs Service. Finally, the fan itself may be defective, if so: 1. Disconnect the control unit from the mains. 2. Replace the fan with one that has the same power rating.
R
Ryan BanksAug 12, 2025
Why will the Klafs 16033 Spa Accessories control unit not switch on?
- M
  Micheal JonesAug 13, 2025
  If the control unit for your Klafs Spa Accessories won't switch on, the first thing to check is the power supply. Make sure to check the FI switch and the fuse.
D
Dr. Sara PollardAug 18, 2025
What to do if the LED flashes on the Klafs 16033 Spa Accessories humidity sensor (SANARIUM M)?
- E
  Erin WestAug 18, 2025
  If the LED on the humidity sensor is flashing and the cloud symbol is flashing on the control unit display (SANARIUM M), it indicates a lack of water. Refill the evaporator M with water.
S
Sara MitchellAug 23, 2025
What does it mean if the LED on the Klafs 16033 Spa Accessories evaporator lights up (SANARIUM S)?
- M
  Matthew WalterAug 23, 2025
  If the LED on the evaporator is lighting up, and the cloud symbol in the control unit display is flashing (SANARIUM S), it means there is a lack of water. Open the angle valve on the evaporator.
A
alexanderbauerAug 28, 2025
How to fix Klafs 16033 Spa Accessories if steam does not exit (SANARIUM S)?
- K
  Kerry MartinAug 28, 2025
  If steam isn't coming out of your SANARIUM S, first check if the angle valve on the evaporator is closed. If it is, open it. Also, verify that the evaporator is switched on; if not, switch it on.
V
vhernandezSep 2, 2025
How to troubleshoot problem 91 in Klafs 16033 Spa Accessories?
- G
  Gregory MeyerSep 3, 2025
  To address problem 91 with your Klafs Spa Accessories, first, remove any object from the cover over the heater. Also, inspect the grille to see if it's loose; if it is, reinsert it.