Klafs 16033 - Starting Up the Evaporator

SANARIUM M, S
PAGE 17
5070189/02.03
5. Operation
5.10. Starting up the evaporator
Filling the SANARIUM M evaporator
2
Fill the evaporator only when it is cold.
Fill in the quantity of water for the
intended bathing duration.
2
Refill SANARIUM M evaporator
Refill the evaporator while in a warm state:
The difference in temperature leads to
mechanical tensions in the tank which can
become noticeable by a noise during
refilling.
3
Do not add any additives to the water.
1. Close the drain cock (1) – move the drain cock to
the left.
2. Fill the evaporator with water at the filling unit (2).
. The filled quantity can be read off the filling level
indicator (3).
1
Fill the scent into the scent cup
1. Take the scent cup (4) off the steam outlet (6)
with the scent fork (5).
5 4
Risk of fire!
Do not fill the scent cup on the heater.
2. Fill the scent cup with diluted scent.
3. Re-insert the scent cup (4) in the steam outlet (6).
6