SANARIUM M, S
PAGE 11
5070189/02.03
5. Operation
Button: Description:
A Cabin light button
B Operatingmodebutton
C Left/Right buttons
D Up/Down buttons
E OK button
Programs:
Sauna temperature:
SANARIUM temperature: Humidity
1 Individual program 1 Individual program Individual program
280°C 250°C
approx. 35 g/m
3
390°C 355°C approx. 50 g/m
3
495°C 460°C approx. 70 g/m
3
570°C approx. 70 g/m
3
Prerequisite/note for the operation described below:
d The control unit is in standby mode. The time appears in the display.
. The selected program starts automatically three seconds after the last press of a button.
5.4. Starting sauna operation
RISK OF FIRE!
Before operating the control unit, always make sure that there are no combustible
objects on or near the sauna heater.
To have a sauna empty the evaporator water tank.
' See Chapter 5.11. - Putting the evaporator out of operation.
1. Press the B button.
. The operating mode selected most recently and its settings appear in the display.
2. If necessary press the B button again until SAUNA appears in the display.
' If other values are to be used for the selected program - see Chapter 6.
Or:
3. Select the desired sauna program using the up/down
buttons.
. Each further press of the button displays the next sauna program.
4. Start sauna operation using the
button.
. At the end of the heating phase the bathing visitor
symbol appears in the display. The sauna is
ready for bathing.
To Next Page
Loading...
