SANARIUM M, S
PAGE 16
5070189/02.03
5. Operation
Program end
SaunaPUR bathing operation
LED activated/deactivated
SaunaPUR button
Starting/ending the form of bathing
7 segment display
Sauna time
Sauna actual temperature
SANARIUM actual humidity
The four digit 7 segment display
shows the following information
alternately:
Temperature for the SaunaP
UR form of bathing not reached yet
5.9. Internal display with SaunaP
UR
button (optional)
The internal display with SaunaPUR button can be delivered as an optional feature. Refer to the delivery
papers for the items included in delivery.
Function
The internal display with SaunaP
UR button is used for
d showing the SaunaP
UR operating mode
d Displays operating values during Sauna/SANARIUM operation
d starting/ending the SaunaP
UR form of bathing.
Starting the SaunaP
UR form of bathing
. Requirement: Setpoint temperature must be reached. The
symbol must appear in the display.
' Start sauna operation if required, see Chapter 5.4.
. It is possible to start the SaunaP
UR form of bathing on the control unit or on the internal
display (optional).
1.
Press the SaunaP
UR
button
.
. If
appears in the 7 segment display, wait until the temperature for the SaunaPUR form of
bathing is reached. Then try again.
. During the SaunaP
UR form of bathing the
SaunaP
UR
operating mode LED shines.
. After approx. 20 minutes or a temperature drop of approx. 15 Kelvin in the sauna cabin, the
SaunaP
UR form of bathing ends automatically. The sauna heater starts heating again.
Ending the SaunaP
UR form of bathing
1.
Press the SaunaP
UR
button
.
. The LED
SaunaP
UR
operating mode goes out. The sauna heater starts heating again.
To Next Page
Loading...
