Sauna/Infrarot/Softclima/Infraclima
PAGE 12
50701103/02.13
5. Operation
5.9. Wall heater - Starting the evaporator
Filling the evaporator
Fill the evaporator when it is in a cold condition.
Fill with the quantity of water for the intended bath duration.
Refilling the evaporator
If you refill the evaporator in a warm condition:
The temperature difference leads to mechanical stresses in the tank, which becomes
apparent by noise when refilling.
Hot surfaces - Danger of burns!
The heater or the evaporator bowl (2)
can be hot. Use gloves when handling
the evaporator bowl.
1
3
2
1. Close the drain valve (1).
2. Remove the evaporator bowl (2).
Caution!
Do not put additives into the water.
3. Fill the evaporator at the water tank (3) with
water.
. The maximum filling quantity is 2 liters.
Add scent to the evaporator bowl
3
2
Hot surfaces - Danger of burns!
The heater or the evaporator bowl (2)
can be hot. Use gloves when handling
the evaporator bowl.
1. Using gloves, take the evaporator bowl (2) off
the water tank (3).
Risk of fire!
Do not fill the evaporator bowl at the
heater.
2. Pour diluted scent into the evaporator bowl (2).
3. Place the evaporator bowl (2) back on the water
tank (3).
To Next Page
Loading...
