Klafs Sauna - 5.4. Starting the sauna; 5.5. Starting Infrared

Sauna/Infrarot/Softclima/Infraclima
PAGE 9
50701103/02.13
5. Operation
Prerequisite/notice for the following operations:
d The control panel is switched to standby. The time appears on the display.
. The selected program starts automatically three seconds after pressing the last button.
. *) The indicated cabin temperatures with Infrared - Infraclima relate to ambient temperatures of
20 °C - 25 °C.
Programs - temperature:
Programs - temperature/humidity:
Sauna Infrared *) Softclima Infraclima *) Humidity
1 Individual
program
1 Individual
program
1 Individual
program
1 Individual
program
Individual
program
280 °C 234 °C 2 50 °C 2 34 °C
3 85 °C 3 37 °C 3 55 °C 3 36 °C
4 90 °C 4 40 °C 4 57 °C 4 38 °C
5 60 °C 5 40 °C
5.4. Starting the sauna
FIRE RISK!
Before starting the control system, always check that there are no inflammable objects
on or near the sauna heater.
To take a sauna, empty the evaporator water tank.
' See Section 5.10., 5.12. - Shutting down the evaporator.
1. Press the MODE button.
. The last selected mode and settings appear on the display.
2. If necessary press the MODE button again until SAUNA appears on the display.
. After the heating phase the Bather symbol
appears on the display. The cabin is ready for
use.
' If you want to change the values for the selected program - see Section 6.
5.5. Starting Infrared
1. Press the MODE button.
. The last selected mode and settings appear on the display.
2. If necessary press the MODE button again until IR appears on the display.
. After the heating phase the Bather symbol
appears on the display. The cabin is ready for
use.
' If you want to change the values for the selected program - see Section 6.