15
EN
Transportation and Placement
• The incline angle of the cabinet should not be over 45°C during transportation.
Do not turn the ice maker upside-down as this may damage the compressor or
refrigerating system.
• Place on a at and stable surface for use.
• At least about 150 mm space should be left around the ice maker to ensure good
ventilation.
• Please adjust the feet when placing the ice maker somewhere, otherwise the water
level will be effected and so does the ice shape.
• The outlet of drainage tube should be lower than the cabinet so as to drain water
easily.
• Do not locate this appliance immediately below a socket outlet.
• Make sure that the appliance is not placed near heat sources and aggressive
gases.
• Do not use near or in the immediate vicinity of a bath or swimming pool or any
source of liquid.
• Before using the ice maker for the rst time, you should wait about 12 hours after
positioning it in a proper place.
Special Notes
• When positioning the unit, make sure that the power cord is not pinched or
damaged.
• Make sure that there are no multiple sockets or power supplies on the back of the
unit.
WARNING
When using, servicing and disposing of the unit, pay attention to the left
symbol on the rear of the unit or on the compressor. This symbol warns
of possible res. There are ammable substances in the refrigerant lines
and in the compressor. Keep the appliance away from sources of re
during use, maintenance and disposal.
To Next Page
Loading...
Need help?
General