21
EN
Problem Possible Cause Suggested Solution
The indicator light “FAULT“
illuminates.
1.) Ice has jammed in the
appliance and has not
fallen into the ice storage
container.
1.) Check that the solenoid
valve is open. Replace it
if not.
2.) The water tank is not in
the correct position.
2.)
• Check whether the
switch (SQ1) can
receive information
from the rotation of
the unbalance wheel.
• Check whether the
rotating motor and
the unbalance wheel
spin.
• Check whether
the motor gear is
damaged by turning
the unbalance wheel
by hand.
Indicator lights
Indicator Possible Cause
No indicator is on. Connect the appliance to the power
supply. The appliance is currently in self-
analysis mode.
The “RUN“ indicator light is on. The appliance is in normal operation
mode.
The “ICE FULL“ indicator light is on. The storage container is full or the tem-
perature is less than 5°C.
The „CLEAN“ indicator light is on. Press the “Clean“ button for 3seconds.
This activates the cleaning function. The
appliance is cleaned for 20 minutes and
then goes through an ice making cycle.
After approx. 40 minutes, the cleaning
process is completed and the indicator
light goes out.