9.1 FX Loop Position
When the FX LOOP is activated, the two switches on the front panel change the signal routing.
For the ultimate in creative exibility, the entire CAB Impulse Response Loader, Power Amp
Simulation and Ambience block can be positioned pre or post FX Loop using the DUAL IR
CABINET SIMULATION PRE/POST toggle switch. In addition, the same exibility is available for
the True Double Tracker circuit using the TRUE DOUBLE TRACKING toggle switch.
For example, many audio engineers traditionally apply stereo effects (usually reverb and delay)
after the cabinet in the recording signal chain so the clarity of the effects can be achieved as
cleanly as possible. This is even more the case when using double tracking etc. so that the
carefully constructed doubled extra weight you have added to your tone doesn’t turn into mush.
However it all depends on your tonal desires – which is why we gave the exibility here for
different connection scenarios- Choose what sounds best to you!
To see the routing in detail, check out the signal ow diagram in the
section.
To Next Page
Loading...
