KMC Controls 68 Series

11
ASSEMBLY SET-UP
GENERAL:
Most of the general set-up and assembly for your KMC Ripper Bedder has been performed at the fac-
tory. Those items not installed at KMC will be reviewed later in this section. For your convenience,
please see the “Overhead Layouts” portion at the end of this section, to ensure proper positioning for
the size and configuration of your KMC Ripper Bedder.
RIGID RIPPER BEDDER
W/RESET ON THE GO
RIGID RIPPER BEDDER
W/TOGGLE TRIP
STACK-FOLD
RIPPER BEDDER
W/RESET ON THE GO
STACK-FOLD
RIPPER BEDDER
W/TOGGLE TRIP