Key Management Systems Ltd 14 | P a g e
Quick Start
If you have installed a Simplekey 4 system previously the following procedure
provides a quick, high-level description of the steps needed to get the system up and
running.
Note: If this is the first time you have installed a Simplekey 4 system
the steps are described in detail in the subsequent pages.
To set up a Simplekey 4 system:
1 Install the Simplekey 4 controller (complete with power supply).
2 Install readers, cabling and Request to Exit switches
3 Install the antenna.
4 Install the locks and cabling.
5 Connect any auxiliary inputs.
6 Commission the system with KMS.
Note: It is essential that each component is installed and connected in line with the
system configuration agreed with KMS.
Each system is supplied with a full configuration document,
connection labels and QR codes providing information as to which
door it is to be connected.
Commissioning the system must involve calling KMS and a walk-
through to ensure that all aspects of the system are working as
expected.
Failure to fully commission a system may result in incorrect
operation and reduced functionality. KMS are unable to support any
system that has not been commissioned.
To Next Page
Loading...