KNF N838 E Series - Directives and Standards

Safety
Diaphragm pump N838_E
10
Translation of Original Operating and Installation Instruction, KNF
347394-347605 09/23
§
Fuels
§
Explosives and flammable materials
§
Fibers
§
Oxidizing agents
§
Foodstuffs.
As standard, the pumps must not be used for simultaneous
generation of a vacuum and positive pressure.
This function can be made possible on a project basis follow-
ing consultation with KNF Customer Service.
Do not apply positive pressure to the inlet of the pump.
This function can be made possible on a project basis follow-
ing consultation with KNF Customer Service.
2.7 Directives and standards
EU/EC
Directives
Installation declaration – for partly completed machinery
With respect to the Machinery Directive 2006/42/EC, the
pumps are partly completed machinery and are, therefore, to
be regarded as not ready for use. Partly completed machinery
may not be commissioned until it has been determined that
the machine into which the partly completed machinery is to
be installed complies with the provisions of the Machinery Di-
rective 2006/42/EC. The following fundamental requirements
of Annex I of Directive 2006/42/EC (general principles) are
applied and observed:
§
General principles no. 1
§
No. 1.1.2. / 1.1.3. / 1.3.1. / 1.3.3. / 1.3.4. / 1.4.1. / 1.5.1. /
1.5.2. / 1.5.8. / 1.5.9. / 1.7.4. / 1.7.4.1. / 1.7.4.3.
Standards The following standards apply:
§
EN IEC 55014-1/2
§
EN IEC 61000-3-2
§
EN 61000-3-3
§
EN IEC 63000
The protective goals of the following directive(s) are achieved: