Knikmops KM 80 - Table of Contents

Table of Contents
Contents
1. Introduction_______________________________________________________________________________ 1
1.1 About these instructions_______________________________________________________________ 1
1.2 Version history_________________________________________________________________________1
1.3 Target group___________________________________________________________________________ 1
1.4 Symbols used__________________________________________________________________________ 2
2. Machine numbers_________________________________________________________________________ 3
2.1 Machine identification_________________________________________________________________ 3
2.2 Type plate______________________________________________________________________________3
3. Intended use______________________________________________________________________________ 4
4. Safety______________________________________________________________________________________5
4.1 Safety instructions_____________________________________________________________________ 5
4.1.1 Instructions before use of the machine and attachments____________________ 5
4.1.2 Instructions for the user______________________________________________________7
4.1.3 Instructions for use of the machine and attachments________________________ 7
4.1.4 General safety instructions___________________________________________________ 9
4.2 Safety symbols on the machine_______________________________________________________10
4.2.1 General safety symbols_____________________________________________________ 10
5. Description of components_______________________________________________________________13
5.1 Overview_____________________________________________________________________________ 13
5.2 Dashboard____________________________________________________________________________14
5.2.1 Dashboard type 1 – standard version_______________________________________ 14
5.2.2 Dashboard type 2___________________________________________________________ 15
5.3 Hydraulic operation__________________________________________________________________ 16
5.3.1 Hydraulic operation – standard version_____________________________________ 16
5.3.2 Hydraulic operation – TE version____________________________________________ 16
5.3.3 Hydraulic operation – eHC version__________________________________________ 17
5.3.4 Sticker for hydraulic operation______________________________________________ 19
5.4 Connector plate______________________________________________________________________ 20
5.4.1 Connector plate with manually operated locking pin________________________ 20
5.4.2 Connector plate with hydraulically operated locking pin____________________ 21
6. Operating the machine___________________________________________________________________ 22
i
Table of Contents