Knikmops KM 80 - Cleaning the Machine; Cleaning with a High-Pressure Cleaner; Problems Caused by Improper Cleaning

Always use new hydraulic fluid when topping up.
10.15 Cleaning the machine
You must clean the machine at regular intervals. That way, you will keep the
machine in good condition and make it easier to operate the arm and other
controls.
You can clean the machine in a number of different ways. Remember to exercise
caution when using certain cleaning agents. They must be properly diluted in
clean water before use, otherwise there is a risk of damaging the machine.
If using a high-pressure cleaner, follow the instructions in Cleaning with a high-
pressure cleaner on page 81.
Note!
Gebroeders Geens cannot be held liable for damage resulting from a failure
to observe the points above.
10.15.1 Cleaning with a high-pressure cleaner
Caution!
Lubricate the lubrication points again after cleaning the machine.
If cleaning the machine with a high-pressure cleaner, the following must be taken
into account:
• Do not direct the high-pressure cleaner at electrical components.
• Do not direct the high-pressure cleaner at bearings, hinges, or lubrication
points.
• For the first three months, only use water with a temperature of up to 15°C and
a maximum pressure of 40 to 60bar.
• The temperature may be increased to 60°C after three months.
• Keep the high-pressure cleaner at least 50 cm away from the chassis.
Failure to follow these instructions may give rise to paint damage and impair the
functioning of the machine itself.
10.15.2 Problems caused by improper cleaning
Problem Cause
Machine remains dirty after cleaning.
Poor choice of cleaning agent, water temperature
too low, or machine not rinsed off properly.
Residue of a solid substance on the paint surface
after the machine has dried.
The machine was not rinsed off properly which
has caused the cleaning solution to dry on the
paint surface.
Maintaining the machine
81