Figure 23: Coupling with a manually operated locking pin
1 Drive the machine up to the attachment that you wish to couple.
2 Lower the arm as low to the ground as possible.
3 Tilt the connector plate (C) forward.
4 Drive the machine forward until the connector plate makes contact with the
attachment.
5 Raise the connector plate until the attachment is fully against the connector
plate.
You may need to tilt the connector plate backward slightly in this step.
6 Move the locking pin lever (E) to the lock position.
7 Check that the locking pin (D) has been ejected and that the locking pin has
secured the attachment.
8 If necessary, connect the hydraulic hoses for the attachment to the
connections for the hydraulic assistance functions (A) and (B).
Warning!
Ensure that the assistance functions are properly connected.
Operating the machine
37
To Next Page
Loading...