ENGLISH
Kodak Professional large format 4000 series printers
11
Loading roll media
Note: If you are using the takeup roll, be sure that a media core is
installed on it. Attach the leading edge of the media to the takeup
roll with three pieces of tape: one at the left, right, and center of the
core. Orient the media as shown in the above illustration.
As printing progresses, media loops down in front of the takeup
core and is detected by the sensor on the printer stand leg. The
takeup roll is then activated to roll the media.
Be sure not to block the sensor.
2 Adjust the media edge guides on the back of the printer. 1/16" gap
spacing is optimum.
Using the second feed roll
The takeup roll can also be used as a feed roll. If you use the takeup roll as a
feed roll, you cannot use the takeup system. If you want to use the takeup roll
as a feed roll, set the printer to ROLL2 by pressing Setup/Paper Options
Menu/Supply Type/Roll2. Follow the loading instructions in the previous
section using the bottom roll.
To Next Page
Loading...
Need help?
General
