Kodak Professional large format 4000 series printers
12
Loading Roll Media Using Roll2
WARNING: When using the ROLL2 option, the media has a tendency to curl
inward under the bottom roller. This could block the media sensor and prevent
the reed roller from feeding media. Make sure you keep the media turned
outward, away from the media sensor.
Using the takeup roll
The takeup roll allows unattended printing by automatically winding printed
media onto a core. In this mode, the automatic cutter is disabled. When using
this option, be sure that the media sensor on the printer's right leg is not blocked.
Depending on the ambient humidity, temperature, and amount of ink coverage,
you may want to turn on the dryer and/or set a dry time as described in the
Reference Guide on the system CD-ROM. If you are using the dryer, position it
so that the fans blow on the media.
➪ To use the takeup roll:
1 Set the printer to Takeup mode by pressing Setup/Paper Options
Menu, Supply Type/Takeup, then press OK. This enables the
takeup roll and disables the cutter.
2 Install an empty core onto the takeup guides. Be sure that the core
width matches the width of the media you are using.
3 Slide the roll guide into the media core, and secure it by tightening
the locking mechanism.
To Next Page
Loading...
Need help?
General
