A-61075 March 1997
FC-4
Function code listing
Code Function Code Name Description
F01 Select Application Allows you to select one of the predefined application
Mode modes. Enter a value from 1–18.
F02 Restore Application Allows you to restore the current application mode to its
Mode original preprogrammed user-defined status.
F04 Count Only On/Off Allows you to count the number of documents entering
the scanner without scanning the documents. The Count
Only Counter will be reset to zero (0) when this function
is selected and displayed in the Status Display. All
accessories are inhibited when the Count Only Function
is enabled.
F05 Accessory Status Displays the current status of the optional accessories
(except Footswitch), software functions (Skew Monitor
and Length Monitor), and confirmation tone selections.
The status of the first accessory/function is indicated in
the Status Display. Press the Enter key to display, one
at a time, the status of the next and subsequent
accessories and functions. The various status conditions
are:
On Via Fnc Code
which indicates that the
accessory, function, or tone is enabled using the
appropriate Function Code;
Off Via Fnc Code
which
indicates that the accessory, function, or tone is disabled
using the appropriate Function code; or
Not Machine Set
which indicates that the noted accessory has not been
software enabled for the scanner.
F07 Level 0 Allows you to define the next document scanned as a
Level 0 document.
F08 Last Image Address Allows you to display the Image Address of the last
document scanned.
F09 Total Document Allows you to display the total number of documents that
Counter have entered the Feeder (Level 3, Level 2, Level 1, or
Level 0 documents). The Total Document Counter may
be preset or reset by entering zero (0) or any valid
number. The Total Document Counter also resets to
zero (0) when 999,999,999 is reached.
To Next Page
Loading...
