Setting Up the Printer
April 9, 2007 2-7
6. Remove the label.
7. Insert the right side of the take-up spool into the spool holder on the
right.
8. Insert the left side of the take-up spool in the spool holder on the left.
9. Adjust the take-up spool until the spool locks into the spool holder.
IMPORTANT: Slack in the ribbon can cause a paper jam.
10. Turn the supply spool to remove any slack in the ribbon.
11. Close the top cover.
Turning On the Printer
1. Press the power switch to on ( | ).
On the operator panel, the orange Power light illuminates and the
Ready message appears when the printer is initialized.
2. To turn off the printer, press the power switch to off ( ).
Take-up spool
On
Off
To Next Page
Loading...
