3-6 April 9, 2007
Calibrating the Printer
3. Examine the test print from the printer to determine the most neutral
gray patch, and then click the patch in the Calibration Utility screen that
corresponds with the most neutral patch on the test print.
IMPORTANT: Only do Step 4 if you want to adjust the highlights so that
your prints meet your personal preference. After adjusting
the highlights, check your prints to make sure that they
look the way you want.
4. Move the slider to adjust the highlights.
IMPORTANT: If you selected a patch in Step 3 or adjusted the highlights
in Step 4, you must do Step 5.
5. Click Update Printer Calibration.
The calibration utility calculates a new calibration table, which is
downloaded to the printer and updates any adjustment you made to
the highlights.
6. Click Print Test Image to make another test print to check the
calibration results.
NOTE: Do Steps 3 - 6 until patch 25 is the most neutral gray.
To Next Page
Loading...
