4-4 April 9, 2007
Operating the Printer
Changing the wait
time
Wait Time Press Enter to change wait time from 0 to 100 seconds. The default is
1 second. This only applies when printing 4R prints using 6R ribbon.
The wait time is the length of time that the printer waits before it starts
printing after receiving a 4R print. This allows the printer to receive a
second 4R print that will print at the same time as the first 4R print.
This decreases the print time when printing multiple 4R prints using
6R ribbon. Press:
• Wait Time
• Enter
• “+” or “-” to change the number
• Enter
•Clear
Printer Setting Operator Panel
Display
Action Required
To Next Page
Loading...
