Kodak DC265 - Page 126

10-8
Pictures remaining number
does not decrease.
The image resolution
does not take up
sufficient space to
decrease the picture
remaining number.
The camera is
operating normally.
Continue taking
pictures.
Using IBM Thinkpad 770E -
USB, the camera does not
appear in the Device Manager
under the USB host controller.
The Thinkpad has the
external floppy drive
connected during the
initial installation of
the camera.
Disconnect the floppy
drive and attach the
camera.
Shut down the
computer and attach
the floppy drive again.
Now you can connect
and disconnect the
camera without
disconnecting the
floppy drive.
Picture is not clear. The lens is dirty. Clean the lens.
Refer to “General
maintenance and
safety” on page 10-1.
Subject or the camera
moved while the
picture was taken.
Hold camera steady
until the picture is
taken.
The subject is too far
away for the flash to
be effective.
Move so the subject is
less than 3 m(10 ft)
away.
Troubleshooting
Problem Cause Solution