8-33
8
Exposure
Fine Spot Metering
☛
In One-shot AF mode, the exposure setting is locked during Continuous Shooting
mode, but the AE lock indicator does not light in the viewfinder.
Fine Spot metering ( ) limits the
metering area to the center of the
viewfinder as defined by the Fine
Spot metering mark (approximately
6% of the image area for the DCS
520 and 4% for the DCS 560). Use
this mode when you need an
accurate exposure reading of a
specific subject area.
In continuous shooting mode ( )
or high-speed continuous shooting
mode with the Power Drive Booster
E1 ( ), exposure value
determined for the first frame is also
used for the second and consecutive
exposures.
(page 6-6)
This function lets you select Fine
Spot metering linked to the focusing
points. Metering is limited to the
area of the manually selected
focusing point, (approximately 9%
of the viewfinder image area for the
DCS 520 and 6% for the DCS 560).
DCS 520
M
DCS 560
M
L
H
Custom Function F-13
To Next Page
Loading...
