Kodak DCS 500 Series

6-19
6
Configuring
Resetting the Camera to Its Initial Settings
Resetting All Camera Functions
Reset all of the camera’s functions
(except for the custom functions) to
their default settings by opening the
palm door and pressing the Clear
button. After resetting, the camera’s
functions are set as shown below:
Function Setting
Shooting mode Program AE (P) mode
AF mode One-shot AF
Metering mode Evaluative metering
Drive mode
Single exposure ( )
Custom functions Not affected
Caution:
✔ When custom function F-8 is set for center-weighted average metering instead
of evaluative metering, and the metering mode is set to partial metering or spot
metering, pressing the Clear button will reset all of the camera functions except
for the Metering mode, which remains at the current setting.