Kodak DCS 500 Series

2-22
Camera Straps
Two camera straps are included with your camera. You can attach either or both.
Attaching the Neck Strap
Attaching the Hand Strap
Thread the ends of the neck strap
through the strap fixtures as shown.
Pull firmly on the strap to make sure
it is held securely by the buckles.
1 Thread the strap through both
loops in the hand strap pad.
2 Place the three-holed buckle on
the strap and thread through the
camera’s top strap fixture.
3 Thread the other end of the strap
through the camera’s bottom
strap fixture.
CAUTION:
If you are planning to use both
the neck strap and the hand
strap at the same time, follow
the instructions for attaching
both the hand strap and neck
strap (described on page 2-24).
Failure to attach the straps
properly can cause the camera
to drop.