52 www.kodak.com/go/support
Using an Eye-Fi Card
Changing Eye-Fi settings
1 In a picture-taking mode, press the Menu button .
The Settings menu appears.
2 Press to highlight Eye-Fi, then press the OK button.
3 Choose Selective Share (recommended).
When you’re in range of your known Wi-Fi network, turn on the camera to transfer
pictures to your computer or mobile device.
Other Eye-Fi Information
■ It’s critical that you disable (do not turn on) Endless Memory Mode in
Eye-Fi Center Software.
■ As of December 2010, Eye-Fi Cards are certified for use in the countries and
regions in which they were purchased.
■ The Eye-Fi Card has a wireless LAN function. Do not insert the Eye-Fi Card where
Wi-Fi is prohibited, such as while aboard an airplane or in a hospital.
■ Even when you set Eye-Fi to off, the card may transmit radio waves.
■ The card may become warm during use. This is normal.
■ Battery life is reduced when using an Eye-Fi Card.
■ For the best reception when transferring pictures to a computer or mobile device,
the rear (LCD side) of the camera should face the Wi-Fi access point.
For Eye-Fi troubleshooting, see page 56.
Get support for Eye-Fi Cards and Software support.eye.fi
To Next Page
Loading...
