KODAK EKTAPRO
Imager
To be used only with the
KODAK EKTAPRO 1000 Processor
Serial No.
KODAK EKTAPRO 1000 Imager
EASTMAN KODAK COMPANY, Motion Analysis Systems Division
San Diego, CA 92121 Made in U.S.A.
HIGH GAIN
NORMAL
RECORD
STOP
MONITOR
HEADSET
Tripod
Mounting
Imager Cable
Not Used
Gain
Switch
Video Output
Connector
Remote Rec /Stop
Not Used
GAIN SWITCH
The Gain Switch allows you to select NORMAL or HIGH GAIN. The
NORMAL position sets the imager video amplifiers to a standard
gain setting. The HIGH GAIN position sets the imager video
amplifiers to produce approximately one f-stop more sensitivity as
compared to the NORMAL position. Please see {KODAK EKTAPRO
High Gain Imager in Chapter 8 on page 8.1} for details on using
the Gain Switch.
IMAGER CABLE CONNECTOR
Receives the imager cable that is connected to the Processor. All
video, control and power lines between the Processor and the
Imager pass through this connection.
TRIPOD MOUNTING
The mounting plate is located at the center of balance on the
Imager. There are two different threaded holes for attachment to
standard tripods. The smaller hole is threaded to receive a 1/4-20
screw and the larger hole is threaded to receive a 3/8-16 screw.
2.3
To Next Page
Loading...
