LIVE
Then
Press
MENU
CONFIGURATION
MENU
Press the ROC softkey. Then use the left or right
arrow keys to select one of the following three options:
ROC
LEVEL
Record On Command function is
operating. Pictures will be stored
in memory only when and as
long as the user supplied ROC IN
signal connected to the Processor
rear panel is “true”.
OFF
Record On Command
function is off and all record
modes operate as previously
defined.
ROC
ROC
415
Burst ROC is operating. The
number of pictures shown in the
softkey window will be stored in
memory each time the ROC IN
signal transitions to “true."
Any number of frames between 1 and 1000 can be selected. Use the
up or down arrow keys to set the number of frames to be taken.
ROC stands for Record On Command. The user literally takes com-
mand of the record process with the record command signal input at
the ROC IN connection on the rear panel of the Processor. The
power on default for ROC is OFF.
NOTE:
When you are using ROC the image will remain frozen when
there is no ROC input signal present at the rear panel. Use the
INVERT switch to temporarily unfreeze the image.
5.14
To Next Page
Loading...
