CONNECTING
THE SYSTEM
3. CONNECTING THE KODAK EKTAPRO Imager
CAUTION
The processor power must be off before connecting
or disconnecting the Imager.
Mate one end of the imager cable to the connector on the
bottom plate of the Imager. Mate the other end of the imager
cable to the IMAGER A connector on the rear panel of the
Processor.
Do not use force, as there are several locating keys on the cable
that allow it to be inserted only when the cable is rotated to the
correct position. After inserting the cable, turn the knurled ring
on the cable connector until the red stripe is no longer visible.
4. TURN THE AC ON/OFF SWITCH ON
When the picture appears on the video monitor it should look
like this.
LIVE
ID
01
REC
50
EXP
50
IMG
A/1
PIX
256
TIME 08 : 35 : 13 DATE 07 / 18 / 91
EM Processor
AC On/Off
AC Fuses
AC Power
4.4
To Next Page
Loading...
