MAKE YOUR
FIRST RECORDING
To start recording press the RECORD key on either the keypad or
the back of the Imager. The keypad message field and the video
monitor status will display RECORDING.
The recording will automatically stop at the End Of Memory
(EOM). If you want to stop the recording before EOM, you can
press the STOP key on either the keypad or the back of the
Imager. In either case, the message field on the keypad will
display RECORDING STOPPED and the status on the video
monitor will display REC/STOP.
LOOKING AT YOUR FIRST RECORDING
To view the recording you have just made, press the PLAY key on
the keypad. Playback, at a rate of thirty frames per second,
automatically begins at the first frame of the recording. Thirty
frames per second, forward, is the default setting the first time
that the PLAY key is pressed after a recording.
Playback direction and rate can be changed by pressing the
different arrow keys while in the PLAY or PLAY/STOP mode. The
left and right arrow keys control direction. The up and down
arrow keys control playback rate.
You have just recorded at fifty frames per second and played
back at thirty frames per second. Any motion that occurred
during the recording was slowed very little because the record
and playback speeds were almost the same. To slow events
down even more you will need to make recordings at the higher
frame rates.
4.7
To Next Page
Loading...
