PLAY
PLAYBACK MENU
STOP
PLAY
LIVEREADY RECORD
MENU
RET
RET
POS
GO TO
GAMMA
PLAY
FRMT
SNGL
WHT
REF
0.9
OFF
X:+105
Y:+162
REF
MRK
X: 251
Y: 109
VCR
MODE
OFF
VCR
COPY
1.
Install infrared
control link
2.
Set EM
Processor for
AUTO
HOW TO USE VCR AUTO MODE
The VCR AUTO mode is used to monitor an application without
needing the undivided attention of an operator. Set up for AUTO
operation using the following guideline:
Connect the Processor video output to the VCR video input.
Connect the infrared control link to the processor rear panel and
attach the other end to the VCR remote control window.
Set up and make a test recording to make sure that you are getting
the image data that you want at the appropriate record rate,
exposure and so on. Check the infrared control link by using the
VCR COPY mode.
Choose a playback rate that will be usable when recorded and
played back from a VCR.
5.30
To Next Page
Loading...
