Kodak HERO 9.1 - Page 63

www.kodak.com/go/aiosupport 57
KODAK HERO 9.1 All-in-One Printer
Using default settings to print a picture
Unless you change the default settings, the default for printing pictures is one
4 x 6 in. / 10 x 15 cm picture. (To change the default settings, see Save as Defaults,
page 59.)
To print a picture from a memory card or USB-connected device using the default
settings:
1. Insert the memory card into the appropriate slot, or connect the digital camera
or portable drive to the front USB port, then touch
View Photos.
IMPORTANT: Use only one slot or port at a time.
2. Touch or to locate the picture you want to print.
3. Press to begin printing.
The printer prints a single 4 x 6 in. / 10 x 15 cm picture.
IMPORTANT: To prevent loss of data from your memory card, do not remove it from the
printer while printing.