106 A-61560 January 2007
4. Remove each tire by sliding the tire off the core.
5. Install each new tire by gently pulling it over the core.
6. Replace the separation roller in the separation roller housing. Be
sure the separation roller snaps into place.
7. Reinstall the separation module.
Replacing the pre-
separation pad
1. Remove the separation module from the scanner by following the
steps described previously in “Replacing the separation module and
tires”
2. Find the pre-separation pad on the separation module.
3. Hold the separator module in both hands and find the two pre-
separation pad side tabs which protrude slightly from the back of the
separation module.
4. Push on the pre-separation pad side tabs on the back until the pre-
separation pad protrudes slightly from the front of the separation
module.
To Next Page
Loading...
