10 A-61560 January 2007
Connecting the power
cord to the scanner
Use only the power supply that was provided with the Kodak i1200/
i1300 Series Scanner. Do not substitute another power supply model or
another manufacturer’s power supply.
After the drivers have been installed, connect the power supply and
power cord to the scanner. Make sure that the power outlet is located
within 1.52 metres (5 feet) of the scanner and is easily accessible.
1. Select the appropriate AC power cord for your region from the
supply of power cords packed with your scanner.
2. Attach the power cord for your power type to the power supply.
3. Plug the output power cord from the power supply into the power
port on the scanner.
4. Plug the other end of the power cord into the wall outlet.
To Next Page
Loading...
