A-61789/ISIS January 2016 7
Mode — select one of the following modes:
• Black and White: if you want your electronic image to represent all
elements of your document in black and white.
• Grayscale: if you want your electronic image to have a range of
varying shades of gray from black to white.
• Color: if you want your electronic image to be in color.
• Auto Detect Grayscale: sets auto color detect for grayscale. See
the section entitled, “Auto Color Detect tab” for more information.
• Auto Detect Color: sets auto color detect for color. See the section
entitled, “Auto Color Detect tab” for more information.
Toggle Patch — indicates you want to tell the scanner, via a toggle
patch document, if the document is color/grayscale or black and white.
• Off: no patches will be used.
• Same Side: only the side which recognizes the patch sheet will
toggle.
• Both Sides: a patch will be recognized on either the front or the back
side.
Buttons — the buttons on the bottom of the window apply to all tabs:
• Copy ⎯ this function is only available when scanning two-sided
documents. The Copy button provides a convenient way to set up the
color, grayscale or black and white image settings on one side and
transfer them to the other. For example, if you highlight and set up
Front Image #1, you can use the Copy button to duplicate those
settings for Back Image #1.
• OK ⎯ saves the values set on all tabs.
• Cancel ⎯ closes the window without saving any changes.
• Help — displays on-line help about the options available on the
selected window.
• Default ⎯ resets the values on all tabs to the factory defaults.
To Next Page
Loading...
