A-61671 / TWAIN February 2013 29
Once you have done this, the Side option on the Image Settings
window will no longer be grayed out and you can select different
settings for each side. Now that you have enabled Different settings
per side, your initial selections will apply only to the front side of the
document you are scanning. After you have made your selections for
the front side, use the Side option to select the back side and then
make the settings you want to apply to the back.
White background — when turned on, indicates which side(s) of the
document will see White instead of Black where there is no paper.
• (none): uses the Black background for the front and back sides.
• Both Sides: uses the White background for the front and back sides.
• Front Only: only uses the White background for the front side, the
back side will use Black. This option is only available when Input
document is is set to Two Sided and Different settings per side is
turned on; or Input document is is set to One Sided - Front.
• Back Only: only uses the White background for the back side, the
front side will use Black. This option is only available when Input
document is is set to Two Sided and Different settings per side is
turned on; or Input document is is set to One Sided - Back.
The following are examples of when white background is used:
• Scanning non-rectangular documents and, in the final image, you
want the area outside the document to be White instead of Black.
• Scanning lightweight or thin paper, with printing on one side, and you
do not want the black background to bleed through the document and
appear in the final image.
To Next Page
Loading...
