48 A-61671 / TWAIN February 2013
Device - Stacking tab The Stacking tab allows you to set options for separating documents
into the two stacks of the Kodak Controlled Stacking Accessory output
tray.
NOTE: The Stacking tab is only available when the Kodak Controlled
Dual Stacking Accessory has been enabled for your scanner.
On — turns stacking on and makes the rest of the options on this tab
available.
NOTE: Stacking also may be overridden to be On or Off from the
scanner’s touchscreen.
Stack to put detected documents in: indicates which stack
documents matching the Detect Based On settings will be placed in.
All non-matching documents will be placed in the other stack.
NOTE: Because document weight and condition can impact the ability
of documents to stack optimally, it is recommended that when
you separate documents less than 6 inches/152 mm (e.g.,
checks) you place them in stack 1; and when separating
documents longer than 6 inches/152 mm (e.g., patch sheets)
you place them in stack 2.
To Next Page
Loading...
