Kodak KODASCOPE EIGHT 70 - img012

OILING . ••
The Kodascope must be oiled before using it for the first time, and it
must be kept clean. Obviously all machinery needs oil and if the Koda-
scope should remain idle for any length of time, it should be oiled
again before using. There are three plac es that should he lubricated ;
two
are on the top of the Kodascope , see illustration above. A few
drops of oil should be added occasionally to the safety shutter oil
retainer, see lower illustration on page I I . All other bearings are selj-
lubricating, and
need no oiling.
Kodascope Oil, a bottle . of which is supplied with the Kodascope, is
preferable to any other, but ordinary sewing machine oil may be used.
In any case use only very small quantities. A few drops in eac h of the
oil holes will
be sufficient. Apply the oil with the wire fastened in the
cork of the bottle.
CLEANING THE GATE • ••
The GATE which guides the film as it passes the lens, must be cleaned
10