Kodak KODASCOPE EIGHT 70 - img003

KOOASC ' OPE
E I G H T
MOD E L
70
BEFORE operating the Kodascope, study these directions, especially
the directions for
threading and rewinding.
The Kodascope should be placed on a firm table or stand.
The Kodascope can be run on either alternating (25 to 60 cycle) or
direct current but must not be operated on a line higher than 125 volts
or lower thal;l 100 volts, either A.C. or D.C. If the voltage on your line
is not known, inquire of your local electric service company.
Lamps of 300, 400 or 500 watts and of the proper voltage can be
obtained from your Cine - Kodak dealer.