Kodak KODASCOPE EIGHT 70 - img009

the pull-down claw works intermittently, while the sprocket runs con-
tinuously.
Place the empty or TAKE-UP REEL on the TAKE - UP SPINDLE. The reel
must be pushed in so that the spring on the spindle snaps into position.
Thread the film on the TAKE-UP REEL by holding the end of film against
the core and turning the reel at least one turn in a clockwise direction,
as shown by the arrow in the illustration. Wind up any slack that there
may be in the film between the LOWER SPROCKET and core ofthe TAKE-UP
REEL.
When the Kodascope is completely threaded, turn the THREADING
KNOB on the front of the Kodascope counter-clockwise (in the direction
of the arrow) a few times, to see that the film is threaded properly, that
the claws of the pull-down en-
gage with the film perforations,
and that the loop sizes are
maintained.
Turn the LAMP SWITCH to
Motor. Check the loop sizes, if
they remain correct, turn the
LAMP SWITCH to Lamp.
7