Kodak KODASCOPE EIGHT 70 - img004

INSERTING THE LAMP . ..
Loosen the screw directly above the name-plate on the back of the
Kodascope and slide the LAMP HOUSE up and off. Draw out the CHIMNEY.
Insert the lamp into the SOCKET with the larger flange over the larger
opening; press it down into the SOCKET and give it a quarter-turn to the
right until it snaps into position. Place the LAMP COVER on the lamp .
Replace the CHIMNEY, slipping the CLIP into the SLOT; then push the
CHIMNEY all the way down.
Replace the LAMP HOUSE, engaging the grooves on the front of the
LAMP HOUSE with the tracks of the projector. Fasten the LAMP HOUSE
with the screw.
Illumination of the Room: Before the Kodascope is used, the room in
which the pictures are to be shown should be darkened sufficiently to
allow
the Kodascope to project a brilliant image on the screen. This
does not mean that the room should be totally dark. If the lights are
properly placed , the room ' may be sufficiently light to read in, after the
eyes
of the occupants have adjusted themse lves to the subdued li ghting.
Very often the lights in rooms adjoining that in which the Kodascope
is used do not impair the brilliancy of the projected pictures.
The SPEED ADJUSTING KNOB must be turned to the right (clockwise)
towards the word Fast.
2