Kodak P811 - Scanned Picture Naming Convention; Safely Disconnect the Scanner from Computer; Scan PC Software for KODAK Personal Photo Scanners; System Requirements

16 Customer Support: http://www.pandigital.net/kodaksupport
Scanned Picture Naming Convention
After your first scan, a folder titled PHOTO1 is added to the memory card file structure.
The scanned pictures are saved in the
PHOTO1 folder. Each scanned picture is given a file name with the prefix EK_
followed by a 4- digit sequential number in the order the pictures are stored. For example,
EK_0001.jpg, EK_0002.jpg.
If the file name reaches
EK_9999.jpg in the PHOTO1 folder, a new folder titled PHOTO2 is automatically created to
store subsequent new files, and so on.
There can be up to 9 folders (
PHOTO1..9, EK_0001... EK_9999) on a memory card. If exceeded, the Status/Card
indicator light blinks.
You can now view or edit the files on the memory card using your own photo editing software.
Safely Disconnect the Scanner from Computer
For WINDOWS
1. On the WINDOWS System Tray, click the hardware removal icon as indicated below.
2. Click the ‘Safely remove USB mass Storage device’ message with the corresponding Drive.
3. When the ‘Safe to Remove Hardware’ message appears, you can safely remove the scanner’s USB cable.
For MAC
On the desktop, right-click on the KODAKSCN volume, then select Eject “KODAKSCN”.
Scan PC Software for KODAK Personal Photo Scanners
With the Scan PC Software for KODAK Personal Photo Scanners (Scan PC Software), you can easily scan photos and save the
scanned pictures directly to the connected PC.
System Requirements
 Operating system: WINDOWS XP, WINDOWS VISTA, WINDOWS 7
 Intel Pentium IV processor
 1.2GHZ or better processor speed
 512MB RAM
 10MB free hard disk space
 USB 2.0 compatible
Install Scan PC Software
1. Connect the scanner to your PC (see instructions beginning on page 14), using
the included SD Memory Card.
2. Open a Windows Explorer window.
3. Select
KODAKSCAN>KODAK>Software>KODAK_Scan_PC_Software_Setup_Vxxxx.
4. Double-click the
ScanPC_KODAK_Scanner_Setup_Vxxxx.exe file.
5. In the Install window, select
Scan PC for KODAK Personal Photo Scanners, and
then click
Install.
6. In the Install Wizard window, click
Next.
7. Click
Next to install in default location, or select desired location and then click
Next.
8. In the Ready to Install window, click
Install.
9. After the software is installed, click
Finish.
 Once installed, the
Scan PC Software runs automatically upon PC startup, and the icon stays on the system tray.
 If you want to close the
Scan PC Software temporarily, right-click on the icon and select Exit.
Hardware Removal Icon