Kohler KD83V16

Service and Repair Manual Repair
Exhaust gas system
Specific values
Not applicable.
Tightening specifications
Fig. 184: Exhaust pipes
Reference
Key Screw specifications
Lubricant *
Reuse**
Torque Angle (°)
Step
± 5%
Step
± 5°
1 412AA M12x1.75x50-C3J - Yes 1 67 Nm
49 ft-lb
- -
2 412AB DIN 908 G1/4 A MH No 1 30 Nm
22 ft-lb
- -
3 430AA DIN 939 M10x1.5x22 MH Yes 1 24 Nm
18 ft-lb
- -
Tab. 38: Tightening specifications table
*Lubricants:
MG = Molykote G-n-plus
MW = Castrol Optimol paste white T
MH = Molykote HSC
O = Engine oil
XX = Loctite 243
YY = Loctite 577
**Refer to screws reuse rules. (For more information see: 5.3.2 Screws pre-tightening, reuse and
marking, page 274.)
KD83V16 33525088901_2_1 EN_US
2021-07
© 2021 by Kohler Co. All rights reserved.
163