Kohler KGS - Controller Fault Reset and Module Status; 2.7.1 Fault Reset Procedures; 2.7.2 Module Status Change

TP-6836 4/1430 Section 4 Communication and Accessory Connections
PC
IP xx.xx.xx.02
Ethernet
Network
Modbusr TCP/IP
Category 5e
Modbusr TCP/IP
Category 5e
Note: The PC and the ATS must be on the same subnet.
Note: A crossover cable can be used to connect the PC
to the ATS controller through the Ethernet port.
MPAC
Controller with
Ethernet comm.
board
IP xx.xx.xx.03
Figure 4-6 Remote Network (Ethernet) Connection
MPAC
Controller with
Ethernet comm.
board
IP xx.xx.xx.03
PC
IP xx.xx.xx.02
Device
Last device
RS-485
Converter,
Modbusr/Ethernet
IP xx.xx.xx.05
RS-485
Modbusr
TCP/IP
Modbusr
TCP/IP
Ethernet
Network
PC
IP xx.xx.xx.01
Terminating resistor
(121 Ohms)
Device
Device
RS-485
Device
Modbusr
RTU
RS-485
Modbusr TCP/IP
Category 5e
Modbusr TCP/IP
Category 5e
Figure 4-7 Ethernet Connections to Multiple-Device Network